Item No. |
Voltage V |
Frequency Hz |
Power Kw |
Current A |
Capacity |
Outer Size mm |
JL-NP10 |
220 |
50Hz |
1.5+0.7 |
10 |
10L |
265*410*615 |
JL-NP12 |
220V |
50H |
2+0.7 |
12.3 |
12L |
265*410*615 |
①Boiler water : When tank water is 100℃, the indicator is red.
②Heating: If water is heating , the indicator is green
③Fault: If machine is get some problem, the indicator is red.
④Inlet: Indicator is Green if water is pulling inside:
①When the machine needs to be turned off, press the power switch to turn off all indicators. Tips: For long periods of downtime, it is recommended to unplug the machine for safety reasons.
②Machine Maintenance
③Machine cleaning
Cleaning Unit |
Cleaning Frequency |
|||
Name |
After use |
Every day |
Every week |
|
1 |
Steam Nozzle |
√ |
√ |
√ |
2 |
Water filter plate |
|
√ |
√ |
3 |
Machine cover |
|
√ |
√ |
4 |
Hot water outlet |
|
√ |
√ |
①Mechanical equipment may cause mechanical failure due to operational errors, aging of accessories, etc., resulting in the machine not being able to operate normally. Therefore, the manufacturer’s long-term summary of maintenance/repair experience is compiled into a table. To reduce the user because of simple mechanical failure and wait for maintenance time and related costs. (wearing parts and rubber rings are not covered by the warranty. When the mail power cord is damaged. It must be replaced by a professional.)
② If the machine is not working properly, please check the problem according to the following fault table.
Trouble |
Solutions |
Do not output hot water |
The machine is not heated or has no steam pressure The out put port is blocked or teh valve body is blocked |
No steam output |
Steam nozzle blockage The water level is too high, open the hot water or drain. Insufficient boiler pressure or no heating |
Boiler is full of water |
The water inlet solenoid valve is not tight or blocked. It is necessary to disassemble the valve body to clean or contact the technician for aging |
Air leaking from the vacuum breaker valve |
The gasket is worn out Valve pin to the middle |
Safety valve leak |
The spring is weak and the safety valve needs to be replaced |
Not Heated |
Temperature probe failure Overheat protector failure |
Steam nozzle or hot water port drip |
The gasket is worn out |